Installing the DIMM module
The system board includes 16 (four DIMM channels per processor) DIMM slots for the installation of DDR4
1600/1866/2133 MHz DIMMs.
To install the DIMM module:
Pull the locking latches of the DIMM slot outward.
1.
Place the DIMM module into the socket so the notch and obstruction are aligned.
2.
Press the edge connector of the DIMM module into the slot. Press down firmly so that the locking
3.
latches of the DIMM slot are levered upwards to secure the DIMM module.
Install the access panel (on page 38).
4.
System board module
Removing the system module
CAUTION:
static discharge.
To remove the system board module:
Power down the server and detach all power cords from the power supplies.
1.
Remove the access panel (on page 37).
2.
Remove the DIMM modules (on page 34).
3.
Remove the heat sinks (on page 29).
4.
Remove the processors (on page 31).
5.
Disconnect all of the cables from the system board.
6.
Remove the screws from the system board module.
7.
Lift the front of the system board and pull it away from the rear of the system. Make sure the I/O ports
8.
clear the chassis before lifting the system board.
Remove the system board module.
9.
When removing any component, wear a properly grounded static strap to prevent
Installation 35