Post Error Messages And Beep Codes; Introduction To Post Error Messages - HP ProLiant BL620c - G7 Server Troubleshooting Manual

Action: No action is required.
Redundancy State: This controller has been setup to be part of a redundant pair of
controllers....
...but redundancy is disabled. Redundancy is disabled for an unknown reason.
Action: Contact HP support
Redundant Path Failure: Multi-domain path failure
Action: Check the storage device I/O module and cables to restore redundant paths.
Redundant Path Failure: The logical drive is degraded due to the loss of a
redundant path.
Action: Check the storage box I/O module and cables to restore redundant paths to the logical drive.
Redundant Path Failure: The physical drive is degraded due to the loss of a
redundant path.
Action: Check the storage box I/O module and cables to restore redundant paths to the physical drive.
Redundant Path Failure: Warning: Redundant I/0 modules of this storage box...
...are not cabled in a recommended configuration.
Action: To correctly connect the cables to the storage system, see the product user guide.

POST error messages and beep codes

Introduction to POST error messages

The error messages and codes in this section include all messages generated by ProLiant servers. Some
messages are informational only and do not indicate any error. A server generates only the codes that
are applicable to its configuration and options.
HP ProLiant p-Class server blades do not have speakers and thus do not support audio output. Disregard
the audible beeps information if the server falls into this category.
IMPORTANT:
apply to the server you are troubleshooting. Refer to the server documentation for information
on procedures, hardware options, software tools, and operating systems supported by the
server.
WARNING:
information in the server documentation before removing, replacing, reseating, or modifying
system components.
("Contacting HP" on page 173).
This guide provides information for multiple servers. Some information may not
To avoid potential problems, ALWAYS read the warnings and cautionary
Error messages 115