Connunitportnodewwn; Connunitporthwstate; Connectivity Unit Event Table; Connuniteventtable - HP StorageWorks 2/64 - Core Switch Reference Manual

connUnitPortNodeWwn

Not supported in Fabric OS 2.6.1.
OID
Description
Note

connUnitPortHWState

Not supported in Fabric OS 2.6.1.
OID
Description

Connectivity unit event table

connUnitEventTable

OID
Description
Note
1.3.6.1.3.94.1.10.1.22
The node WWN of the port, if applicable; otherwise, an empty string.
All related ports within a group should have the same node WWN value. The container
is defined as the largest physical entity. For example:
• All ports on HBAs on a host will have the same node WWN. All ports on the same
storage subsystem will have the same node WWN.
• This is in IEEE Extended format; the extension contains the internal port number of each
port.
The internal port number is 1 less than the port index. For example, if the switch has
WWN 10:00:00:60:69:10:02:18, then port number 0 and 6 have WWN
20:00:00:60:69:10:02:18 and 20:06:00:60:69:10:02:18, respectively. However, the
embedded port has WWN 10:00:00:60:69:10:02:18, the same as the switch.
1.3.6.1.3.94.1.10.1.23
The state of the port as detected by the hardware. Possible values are:
• unknown (1)
• failed (2): Port failed diagnostics (port_flt_state).
• bypassed (3): FCAL bypass, loop only (not used).
• active (4): Connected to a device (light and sync are present).
• loopback (5): Port in ext loopback (loopback state).
• txfault (6): Transmitter fault (bad GBIC).
• noMedia (7): Media not installed (GBIC removed).
• linkDown (8): Waiting for activity—rx sync (light with no sync).
1.3.6.1.3.94.1.11
The table of connectivity unit events. Errors, warnings, and information should be reported
in this table.
(3.0 only) This table contains the 64 most-recent event log entries.
(4.0 only) This table contains the 255 most-recent event log entries.
(4.2 only) This table contains the 2048 most-recent event log entries.
(4.4 only) This table contains the 1024 most-recent event log entries.
Only external RASlog messages are supported. Fabric OS 4.4.0 does not have Panic or
Debug level messages. All messages are documented in the HP StorageWorks Fabric OS
5.x diagnostics and system error messages reference guide.
Fabric OS 5.x MIB reference guide 235