Connunitportname; Connunitportphysicalnumber - HP StorageWorks 2/64 - Core Switch Reference Manual

Note

connUnitPortName

OID
Description
Note

connUnitPortPhysicalNumber

OID
Description
Note
• Addition of the port from an arbitrated loop by a hub.
Each implementation might choose not to allow any or all of these values on a SET.
If the management station uses in-band communication (FC-IP) with the switch, either of
the two following actions might result in a loss of in-band communication with the
switch:
• Disabling the FC port that is connected to the management station.
• Disabling the embedded port.
Return values are:
• resetConnUnitPortportDisable (F or E_Port, loop for U_Port)
• bypassConnUnitPort portDisable (FL_Port)
• unbypassConnUnitPort portEnable (FL_Port)
• offlineConnUnitPort portDisable (E, F, FL_Port)
• onlineConnUnitPort portEnable (U)
• resetConnUnitPortCounters clear the port statistics counter. When rebooted, this
defaults to 1 (unknown).
1.3.6.1.3.94.1.10.1.17
A string describing the addressed port.
This object is read-only for HP StorageWorks switches.
1.3.6.1.3.94.1.10.1.18
The internal port number by which this port is known. In many implementations, this
should be the same as connUnitPortIndex. Some implementations might have an internal
port representation that is not compatible with the rules for table indices. In these cases,
provide the internal representation of this port in this object.
This value might also be used in the connUnitLinkPortNumberX or
connUnitLinkPortNumberY objects of the connUnitLinkTable.
The internal port numbers for HP switches. The HP StorageWorks switches support 0
through maximum number of ports.
The maximum number of supported ports are as follows:
• 8 for SAN Switch 2/8-EL and SAN Switch 2/8V
• 12 for the Brocade 4Gb SAN Switch for HP p-Class BladeSystem
• 16 for the 4/8 SAN Switch, 4/16 SAN Switch, SAN Switch 2/16, and SAN Switch
2/16V
• 32 for SAN Switch 2/32 and SAN Switch 4/32
• 64 for the Core Switch 2/64
• 128 for SAN Director 2/128
• 256 for 4/256 SAN Director
Fabric OS 5.x MIB reference guide 233