6.5 When the Error Light is on
When the Error Light (1) is ON or flashing, there is an error.
Confirm
the error number that is shown on the Error Number Display
(2). This number indicates the cause of the error.
6.6
Error Number and its reason
Error
No.
1
FLASH ROM Read/Write is full
Exceeds FLASH ROM Write Number
2
PCB Failure
3
EEPROM Error
4
Thermal Head is broken.
5
Head is not locked.
6
Out of Paper
7
The type of sensor or adjustment of
sensor is not appropriate.
8
Cutter is not connected or is not
installed correctly.
9
Out of ribbon
Ribbon is not installed correctly.
A
Too much data is transferred from a
computer.
There is an error in the communication
condition settings on the computer.
58
Cause
Troubleshooting
Contact
your local dealer.
Contact your local dealer.
Contact your local dealer.
Contact your local dealer.
Press both sides of the print
head to close it firmly (Push).
Replenish paper.
Contact your local dealer.
Contact your local dealer
Only for Cutter type
Set ribbon correctly
Only for thermal transfer type.
Turn the power of the printer
off and on. Adjust the amount
of data of the computer
software according to the
communication condition. If
you still experience the error,
confirm the communication
condition.