Installing the Dispenser Kit
Direct Thermal Unit
STEP PROCEDURE
9. Remove the backing paper from the Guide Sheet. Line up one side of the
Guide Sheet (match notch on Guide Sheet with notch on Front Door Panel).
Press down firmly to attach.
10. Attach connector from the Dispenser Kit to CN13 on the printer as shown.
11. Position the Dispenser Kit with the printer so that the locating pins of the
printer line up with the holes on the Dispenser Kit.
12. Secure with two screws provided.
13. Set the dip switch setting to the dispenser mode.
DSW1
On
DSW2
DSW3
On
Off
SETTING
Dispenser Mode
43