Installing The Cutter Kit - Oki T400 User Manual

4.2.2 Installing the Cutter
STEP PROCEDURE
1. Switch the printer OFF and disconnect the power cord.
2. Raise the top cover and print head assembly.
3. Refer to the illustrations on the following pages.
Remove the front door panel.
4. Raise the tear bar to the upright position.
5. Insert the connector from Item "B" into CN3 on the printer.
6. Install Item "B" by placing the tabs in and down into the slots on the
printer. Be sure the positioning holes on Item "B" are inserted on the
positioning pins. Secure with (2) Item "B" screws.
7. Lower the tear bar to the operating position.
8. Secure Item "A" to the print head with Item "A" screw. Lever on
Item "A" swings down to unlock and up to lock and pivots forward in
the unlocked position.
9. Lower the print head assembly and replace the front door panel and
top cover.
10. Refer to Section2.1 and set the dip switch settings to the cutter mode.
Kit
33