Oki T400 User Manual page 58

Installing the Dispenser Kit
Thermal Transfer Unit:
STEP PROCEDURE
12 . Remove
Guide Sheet (match notch on Guide Sheet with notch on
Press down firmly to attach.
13 . Attach connector fro
14. Position the Dispenser Kit with the prin
printer line up with the holes on the Dis
15. Secure with two screws provided.
16. Set the dip switch settings to the dispenser mode.
DSW1
On
the backing paper from the Guide Sheet. Line up one side of the
m the Dispenser Kit to CN13 on the printer as shown.
DSW 2
On
ter so that the locating pins of the
penser Kit.
DSW3
Off Dispenser Mode
Front Door Panel).
SETTING
51