Control Tab (Configure Status Leds And Motion Detection Sensitivity) - Lorex Vantage LNC116 Instruction Manual

L-View 116 Software
9. Click Update to save changes. Enter the camera admin user name (default: admin)
and password (default: left blank) and click OK. The camera will disconnect. Wait
about 15 seconds and then double-click the camera in Camera List or Auto Search to
reconnect to the camera.
3.8.3 CONTROL TAB (CONFIGURE STATUS LEDS AND MOTION
DETECTION SENSITIVITY)
The Control tab allows you to configure the camera status and network LEDs to make
the camera harder to spot at night. It also allows you to configure the motion detection
sensitivity when using video motion detection.
NOTE: These settings do not affect the SD LED. Removing the microSD card will turn off
the SD LED, but it will also disable microSD recording.
To configure the camera status LEDs:
1. Select one of the following:
• Normal: Status and network LED's will function as normal. For details on LED
functions, see "Camera Overview" on page 1.
• Always turn off: Status and network LED's are turned off at all times.
• Turn off after connected: Status and network LED's turn on when the camera is
powered on and turn off once a network connection is made.
48
Configure status and
network LEDs
Configure motion detection
sensitivity from 1 (High) to
10 (Low)