Iphone Wifi Setup - Lorex Vantage LNC116 Instruction Manual

Getting Started
7. Click WiFi Security again and click WiFi Test (this may take up to 60 seconds).
8. When successful, Status will say Test Success. If unsuccessful, double check your
wireless password and make sure your camera is close enough to the wireless router
to get a good signal.
9. Remove the Ethernet cable from the camera wait 60 seconds and then reconnect to
your camera in L-View.

2.3.2 IPHONE WIFI SETUP

NOTE: The camera must be connected to your router using an Ethernet cable before you
can set it up to use WiFi.
1. Connect to your camera using Lorex Ping iPhone. For details, see "Connecting to
your Camera on iPad" on page 12. Your iPhone must be connected to your WiFi, not
your 3G/mobile network.
2. Tap to open the edit camera screen.
20
WiFi test