Configuring Led Control And Motion Detection Sensitivity - Lorex Vantage LNC116 Instruction Manual

• Time Display on Video: Tap to select ON to enable time stamps on video or OFF to
disable time stamps.
• Video flip: Tap to select Video Flip to flip the camera image vertically and horizontally
or select Normal for the normal orientation. This is useful if the camera has been
mounted to a wall or ceiling upside down.
4. Tap Video Settings when finished making changes, then tap Update to save your
settings.
7.3.5 CONFIGURING LED CONTROL AND MOTION DETECTION
SENSITIVITY
Configure the behavior of the camera status and network LED's. This is useful if you want
the camera to be harder to spot at night. You can also configure the sensitivity for video
motion detection.
To configure LEDs and motion detection sensitivity:
1. In Camera List, tap
2. Tap Video Settings. Then tap Control.
3. Under Status LED, select one of the following:
• Normal: Status and network LED's will function as normal. For details on LED
functions, see "Camera Overview" on page 1.
• Always turn off: Status and network LED's are turned off at all times.
• Turn off after network connected: Status and Network LED's turn on when the
camera is powered on and turn off once a network connection is made.
NOTE: This does not affect the SD LED. Removing the microSD card will turn off the SD
LED, but it will also disable microSD recording.
4. Under Motion Sensitivity, select the motion detection sensitivity between 1 (High)
and 10 (Low). If Motion Detection Sensitivity is set to 1, motion detection will be
next to the camera you would like to edit.
Select Network and Status LED behavior
Select Video motion detection sensitivity
Android App
119