Table of Contents
Advertisement
Chapter 2 Creating Sounds (Patch Edit)
Select an effect you want to move.
Pressing the effect button for the effect you want to move lets you choose the
effect.
4.
Move an effect to the point where you want to have an effect inserted.
5.
6.
If you want to change the sequence further, repeat Steps 4 and 5.
Checking the Effect Level with the Level Meter
In the upper right of the FX CHAIN screen, you can meter the output level of each effect.
To check an effect's output level, move the cursor to the desired effect.
You can check the level of signals being input to the INPUT jack by selecting
Selecting
allows you to check the level of signals output from the GT-10B.
38
Compressor/
Delay
Limiter
OD/DS
Chorus
PREAMP
Reverb
EQ
Pedal FX
Noise
FX-1
Suppressor1
Noise
FX-2
Suppressor2
• Pressing [CATEGORY/ENTER] or the
EFFECTS SELECT button for the currently
selected effect switches the effect on or off.
• There are two effect routes—channel A (upper)
and channel B (lower)—and [CHANNEL
SELECT] is used to select which one to use.
Foot Volume
Send/Return
Digital/USB
Out
INPUT jack
OUTPUT jack
and
• If you want to name the patch or edit the name,
proceed to "Naming a Patch (PATCH NAME)"
(p. 42) before you save.
• If you want to save a name of the patch with
the settings you've made, proceed to "Saving a
Patch (PATCH WRITE)" (p. 43).
.
cannot be moved.
Advertisement
Table of Contents
