Table of Contents
Advertisement
Chapter 8 Parameters Guide
SLICER
This consecutively interrupts the sound to create the
impression that a rhythm backing phrase is being played.
Parameter/
Explanation
Range
Pattern
Select the slice pattern that will be used to
P1–P20
cut the sound.
Rate
0–100,
Adjust the rate at which the sound will be
cut.
BPM
–BPM
When set to BPM, the value of each parameter will be set according
to the value of the "Master BPM" (p. 122) specified for each patch.
This makes it easier to achieve effect sound settings that match the
tempo of the song.
If, due to the tempo, the time is longer than the range of allowable settings, it
is then synchronized to a period either 1/2 or 1/4 of that time.
Trig Sens (Trigger Sensitivity)
Adjusts the sensitivity of the sensor to play
the selected pattern from the beginning.
When strongly picked notes play the
0–100
rhythm of pattern will play from the begin-
ning.
With high settings of this parameter, the
pattern will be restarted from the begin-
ning even by softly picked notes.
116
VIBRATO
This effect creates vibrato by slightly modulating the pitch.
Parameter/
Explanation
Range
Rate
0–100,
Adjusts the rate of the vibrato.
BPM
–BPM
When set to BPM, the value of each parameter will be set according
to the value of the "Master BPM" (p. 122) specified for each patch.
This makes it easier to achieve effect sound settings that match the
tempo of the song.
If, due to the tempo, the time is longer than the range of allowable settings, it
is then synchronized to a period either 1/2 or 1/4 of that time.
Depth
0–100
Adjusts the depth of the vibrato.
Trigger
This selects on/off of the vibrato.
Off, On
It is assumed that this parameter will be
assigned (p. 51) to the footswitch.
Rise Time
This sets the time passing from the moment
the Trigger is turned on until the set vibrato
is obtained.
0–100
When a patch with Trigger set to On is called up,
the effect obtained is identical to what happens
when Trigger is switched from Off to On. If you
want the vibrato effect to be produced
immediately after the patches are switched, set
Rise Time to 0.
Advertisement
Table of Contents
