Table of Contents
Advertisement
Chapter 8 Parameters Guide
SLOW GEAR
This produces a volume-swell effect ("violin-like" sound).
Parameter/
Explanation
Range
Sens (Sensitivity)
Adjusts the sensitivity of the slow gear. When it
is set to a lower value, the effect of the slow gear
can be obtained only with a stronger picking,
0–100
while no effect is obtained with a weaker pick-
ing. When the value is set higher, the effect is
obtained even with a weak picking.
Rise Time
Adjusts the time needed for the volume to
0–100
reach its maximum from the moment you begin
picking.
DEFRETTER
This simulates a fretless bass.
Parameter/
Explanation
Range
Tone
Adjusts the amount of blurring between the
-50–+50
notes.
Sens (Sensitivity)
This controls the input sensitivity of the defret-
0–100
ter.
Attack
0–100
Adjusts the attack of the picking sound.
EffectLev (Effect Level)
0–100
Adjust the volume of the defretter sound.
DirectLev (Direct Level)
0–100
Adjust the volume of the direct sound.
110
BASS SYNTH
This is a synth sound that processes the bass input signal.
• Because of the need to analyze the pitch, chords (two or more sounds
played simultaneously) cannot be played. Be sure to mute all the other
strings and play only one note at a time.
• When you are to play the next string while a certain sound is still playing,
mute the previous sound and then play the next one with a clear attack. If
the unit cannot detect the attack, it may not sound correctly.
• The sensitivity may vary according to the bass's TONE knob and pickup
type.
Parameter/
Explanation
Range
Wave
Selects a wave type which the synth sound is based.
Creates a synth sound with a saw waveform
Saw
(
Creates a synth sound with the square wave-
Square
form (
Cutoff (Cutoff Frequency)
Adjusts the frequency where the harmonics
0–100
contents of the sound are cut off.
Resonance
This adjusts the amount of resonance (and the
tone coloration) in the synth sound. The higher
0–100
the value, the more the synth tone coloration is
emphasized.
FLT.Sens (Filter Sensitivity)
This adjusts the amount of filtering applied in
0–100
response to the input.
FLT.Decay (Filter Decay)
This sets the time needed for the filter to finish
0–100
its sweep.
FLT.Depth (Filter Depth)
Adjusts the depth of the filter. When the value
0–100
is higher, the filter will change more drastically.
Synth Lev (Synth Level)
0–100
Adjusts the volume of the synth sound.
DirectLev (Direct Level)
0–100
Adjusts the volume of the direct sound.
).
).
Advertisement
Table of Contents
