Table of Contents
Advertisement
Chapter 8 Parameters Guide
Pan
Parameter/
Explanation
Range
Tap Time
Adjusts the delay time of the left channel
delay. This setting adjusts the L channel
0–100%
delay time relative to the R channel delay
time (considered as 100%).
Dual-S, Dual-P, Dual-L/R
Parameter/
Explanation
Range
D1:Time (Delay 1 Time)
D2:Time (Delay 2 Time)
1ms–1700ms,
This determines the delay time.
BPM
–BPM
When set to BPM, the value of each parameter will be set according
to the value of the "Master BPM" (p. 122) specified for each patch.
This makes it easier to achieve effect sound settings that match the
tempo of the song.
When setting to BPM, press [CATEGORY/ENTER] to display the
MASTER BPM screen.
If no operation if performed within a set period of time, the display
returns to the Delay screen.
• If, due to the tempo, the time is longer than the range of allowable
settings, it is then synchronized to a period either 1/2 or 1/4 of that time.
• After setting D1:Time or D2:Time to a value from 1 ms to 1,700 ms, you
can press [CATEGORY/ENTER] to set the value for D1:Time or D2:Time
to a value from 1 ms to 1,700 ms according to the interval you press the
button.
When Type is set to Dual-S or Dual-P, D1:Time is not changed.
D1:Fbk (Delay 1 Feedback)
D2:Fbk (Delay 2 Feedback)
Adjusts the amount of feedback of the Delay
0–100
1 (or Delay 2). A higher value will increase
the number of the delay repeats.
D1:HiCut (Delay 1 High Cut Filter)
D2:HiCut (Delay 2 High Cut Filter)
This sets the frequency at which the high
700Hz–11.0kHz,
cut filter begins to take effect. When "Flat"
Flat
is selected, the high cut filter will have no
effect.
D1:Level (Delay 1 Level)
D2:Level (Delay 2 Level)
Adjusts the volume of the Delay1 (or Delay
0–120
2).
120
Warp
Parameter/
Explanation
Range
Warp Sw
Turns the Warp effect on/off.
Off, On
This parameter is assigned to the CTL1, CTL2 or CTL
3/4 jack.
Rise Time
Adjusts how rapidly the warped delay sound
0–100
rises.
F.B.Depth (Feedback Depth)
Adjusts the feedback level of the warped delay
0–100
sound.
Level Dep (Level Depth)
0–100
Adjusts the volume of the warped delay sound.
Modulate
Parameter/
Explanation
Range
Mod.Rate (Modulate Rate)
0–100
Adjusts the modulation rate of the delay sound.
Mod.Depth (Modulate Depth)
Adjusts the modulation depth of the delay
0–100
sound.
Advertisement
Table of Contents
