Table of Contents
Advertisement
OCTAVE
This adds a note one octave lower, creating a richer sound.
Because of the need to analyze the pitch, chords (two or more sounds played
simultaneously) cannot be played.
Parameter/
Explanation
Range
Range
This selects the register to which the effect is applied.
B0 (Low B) to E5 (corresponds to the 1st string
Range 1
played at the 28th fret on six-string bass)
B0 (Low B) to E4 (corresponds to the 1st string
Range 2
played at the 21st fret on four- or five-string
bass)
B0 (Low B) to E3 (corresponds to the 1st string
Range 3
played at the 9th fret on four- or five-string
bass)
B0 (Low B) to E6 (corresponds to the 1st string
Range 4
played at the 24th fret on guitar)
Oct.Level (Octave Level)
Adjusts the volume of the sound one octave be-
0–100
low.
DirectLev (Direct Level)
0–100
Adjusts the volume of the direct sound.
Chapter 8 Parameters Guide
PITCH SHIFTER
This effect changes the pitch of the original sound (up or
down) within a range of two octaves.
Parameter/
Explanation
Range
Voice
Selects the number of voices for the pitch shift sound.
One-voice pitch-shifted sound output in
1-Voice
monaural.
Two-voice pitch-shifted sound (PS1, PS2)
2-Mono
output in monaural.
Two-voice pitch-shifted sound (PS1, PS2)
2-Stereo
output through left and right channels.
PS1/PS2 (Pitch Shift)
Mode *1
Selection for the pitch shifter mode.
The response is slower in the order of
Fast, Medium ,
FAST, MEDIUM and SLOW, but the mod-
Slow
ulation is lessened in the same order.
MONO is used for inputting single notes.
Mono
You may be unable to produce the intended
effect when playing chords (two or more notes
played simultaneously).
Pitch *1
Adjusts the amount of pitch shift (the
-24–+24
amount of interval) in semitone steps.
Fine *1
Make fine adjustments to the interval.
-50–+50
The amount of the change in the Fine 100 is
equivalent to that of the Pitch 1.
PreDly (Pre Delay) *1
Adjusts the time from when the direct
0 ms–300 ms,
sound is heard until the pitch shifted
sounds are inputted. Normally you can
BPM
–BPM
leave this set at 0ms.
When set to BPM, the value of each parameter will be set according
to the value of the "Master BPM" (p. 122) specified for each patch.
This makes it easier to achieve effect sound settings that match the
tempo of the song.
If, due to the tempo, the time is longer than the range of allowable settings, it
is then synchronized to a period either 1/2 or 1/4 of that time.
Fbk (Feedback)
Adjusts the feedback amount of the pitch
0–100
shift sound.
Level *1
0–100
Adjusts the volume of the pitch shifter
DirectLev (Direct Level)
0–100
Adjusts the volume of the direct sound.
*1
With Voice set to 2-Mono or 2-Stereo, you can select two sounds.
111
Advertisement
Table of Contents
