Table of Contents
Advertisement
Chapter 8 Parameters Guide
Parameter/
Explanation
Range
Custom
Setting available when Type is set to Custom.
Type
This selects the basic sound when the TYPE parameter is set to Cus-
tom.
This models the sound of the CRY BABY wah
CRY WAH
pedal popular in the '70s.
VO WAH
This models the sound of the VOX V846.
This wah has been specially adapted for use in
the bass registers.
Bass WAH
Inclusion of the low-frequency range in the
wah sound produces a robust wah effect, with
no dilution of the sound.
Q
Adjusts the amount of characteristic effect ap-
-50–+50
plied to the wah tone.
Range Low
Selects the tone produced when the pedal is
-50–+50
back.
RangeHigh
Selects the tone produced when the pedal is for-
-50–+50
ward.
Presence
-50–+50
Adjusts the tonal quality of the wah effect.
124
Pedal Bend/PB
This lets you use the pedal to get a pitch bend effect.
Because of the need to analyze the pitch, chords (two or more sounds played
simultaneously) cannot be played.
Parameter/
Explanation
Range
Pitch Min (Pitch Minimum)
This sets the pitch at the point where the EXP
-24–+24
Pedal is fully lifted.
Pitch Max (Pitch Maximum)
This sets the pitch at the point where the EXP
-24–+24
Pedal is all the way down.
Pdl Pos. (Pedal Position)
Adjusts the pedal position for pedal bend.
0–100
This parameter is used after it's been assigned to an
EXP Pedal or similar controller.
EffectLev (Effect Level)
0–100
Adjusts the volume of the pitch bend sound.
DirectLev (Direct Level)
0–100
Adjusts the volume of the direct sound.
MONO
Advertisement
Table of Contents
