Phase 2 - Install Hp Drivers - HP Tc2120 - Server - 256 MB RAM Installation Manual

5. If you accept erasing all data on your disk, select Continue. Then press any key
for your system to create the partition, reboot, and format that partition.
6. Press F10 to "Accept License Agreement."
NOTE: You can boot from the NetWare SBS 6 License diskette. Novell DOS 7 and all
required DOS utilities (FDISK, FORMAT, EDIT) are included on the diskette.
7. Change the prompt from Express to Custom, and keep the default New
server option; scroll down and choose Continue.
8. Review the Server Settings. If you do not want the "SERVER" to automatically
load after reboot, Modify the Load Server at reboot parameter to NO.
9. Go to the "Server SET Parameters" and Choose Edit. A window will pop-up and
the following should be added:
i. SET MINIMUM PACKET RECEIVE BUFFERS=2500
ii. SET MAXIMUM PACKET RECEIVE BUFFERS=12500
10. Press Esc, save the changes.
11. Scroll down to select Continue.
12. Review the regional settings and modify if necessary.
13. Review the mouse and video settings and modify if necessary.
14. Wait a few minutes while system files are copied from the CD-ROM.
Phase 2 – Install HP Drivers
1. The installation program then detects your hardware and attempts to match the
drivers to the hardware.
2. If you have an IDE only system, press Enter to continue. If you have another
hardware controller, you need to install the appropriate drivers:
a. Scroll down to Modify and press Enter.
b. Scroll down to highlight the "Storage Adapters" item and press Enter.
c. The installation program displays the drivers detected. Press Delete to
remove the default SCSI driver. The only remaining driver should be the
IDEATA.HAM driver.
52