Section 2. Perform Windows 2000 Installation - HP Tc2120 - Server - 256 MB RAM Installation Manual

2. Insert your HP Startup CD in a Windows PC and follow the on-screen
instructions to create the Windows 2000 SCSI driver diskette (HP disk W2K
SCSI).
NOTE: If the Windows PC does not auto-start the Startup menu, start it by opening
startup.htm, found at the root level of the Startup CD..

Section 2. Perform Windows 2000 Installation

NOTE: Though you may install Windows 2000 from setup diskettes or directly from the
Windows 2000 CD-ROM, we recommend you use the second method because it is faster.
1. Boot your new server from the Windows 2000 CD-ROM.
2. You will see a message that reads, "Setup is inspecting your
hardware configuration." Then the setup screen will be displayed.
3. The system will briefly show at the bottom of the display "Press F6 if you
need to install a third party SCSI or RAID controller."
NOTE: Unfortunately, Windows 2000 setup only gives you a short time to press F6. If you
miss it, reboot your system and start from step 1 above.
If you have a SCSI model:
a. Press S to specify additional SCSI adapters.
b. When prompted, insert the HP disk W2K SCSI you created from tc2120
startup CD.
c.
Press Enter to continue.
d. Select the "Adaptec Ultra 160 Family PCI SCSI
Controller Win 2000," then press Enter.
If you use the IDE RAID model:
a. Press S to specify additional IDE adapters.
b. When prompted, insert the HP disk IDE FastTrack RAID Channel driver you
created from tc2120 startup CD.
10