1.5 Network Configuration; 1.6 More Installation Settings - HP Tc2120 - Server - 256 MB RAM Installation Manual

7. Click Next

1.5 Network Configuration

NOTE: The installer should have detected all of your NICs at this point. If it does not, then you
may need to obtain a special NIC driver that may be installed after you have completed the
Red Hat Linux installation.
1. If you are using DHCP, then click next. Otherwise, select your first NIC and
click Edit.
2. If you chose DHCP, you can skip to step 7. Otherwise, deselect "Configure using
DHCP."
3. Enter the IP address and netmask that corresponds to your network. Click OK.
4. Repeat steps 1 through 3 for each NIC.
5. Select "manually" for "Set the host name" and enter a host name for your
machine (e.g., HP-Netserver1).
6. Enter any required addresses for Gateway, Primary, Secondary, and Tertiary
DNS.
7. At the Firewall Configuration screen, choose the type of firewall configuration,
or "No Firewall" for none. If configuring a firewall, you may choose to "Use
default firewall rules," or "Customize." Click Next to continue.
NOTE: If you accidentally chose to install a firewall, and did not intend to, you can "rm
/etc/rc.d/rc[0-5].d/*iptables*" & "iptables -F" from the root prompt later to get rid of it.

1.6 More Installation Settings

1. On the "Additional Language Support" screen, select English (USA). Click
Next.
2. On the "Time Zone Selection" screen, select location. Click Next.
75