Section 3. Completing The Installation; Phase 1 - Install Hp Supported Driver(S) - HP Tc2120 - Server - 256 MB RAM Installation Manual

Chapter 8
NOTE
You may open the "Manage Your Server" wizard at any point
in time by clicking Start | Programs | Administrative Tools |
Manage Your Server.

Section 3. Completing the Installation

PHASE 1 – Install HP supported driver(s)
During the Windows Server 2003 installation, the OS may not install the most
current HP supported drivers. The following procedure will help you to
install/update the driver(s) using the HP Startup CD.
An Example of installing the Promise FastTrak100 TX2 IDE RAID driver
1. Insert the HP tc2120 Startup CD in your new server. If CD-ROM auto-start
is enabled, a menu will display. You may close this menu.
2. Open Start | Control Panel | System | Hardware | Device Manager.
3. Open the yellow question marked "Other Devices" tree and double-click
on the appropriate "RAID Controller" to display its menu.
4. From the "RAID Controller Properties" dialog box, click the
Driver tab then Update Driver to open the Update Device Driver Wizard.
Click Next.
5. At the prompt "What do you want the wizard to do?" select
"Install the software automatically", and click Next.
6. Wait for the system to find the appropriate driver, and then click Next.
7. Click Finish once the IDE RAID driver has been loaded.
8. Exit all open windows and restart your computer in order to properly
initialize the RAID adapter, if necessary.
9. After restarting Windows .NET, configure the IDE RAID Hard Drives. (See
Section 4, Phase 2 - Initialize Hard Disk Drive).
An example of installing the embedded Compaq NC7760 Gigabit Server Adapter
driver
1. Insert one blank, formatted 3.5" diskette into a workstation's floppy drive.
2. Insert the HP tc2120 Startup CD in your new server to create the Windows
Server 2003 drivers diskette for the embedded Compaq NC7760 Gigabit
Server adapter. If CD-ROM auto-start is enabled, a menu will display and
Installing Microsoft Windows Server 2003
5