Ip Discovery - NETGEAR WMS5316 - ProSafe 16-AP Wireless Management System Reference Manual

ProSafe 16 AP Wireless Management System WMS5316 Reference Manual
Figure 2-1
2. Click Search.
• The Wireless Management System searches for NETGEAR products on the LAN based
on MAC address, and then identifies which are access points.
• The access points located through discovery are displayed on the screen.
3. Check the discovery results to make sure that all the access points are listed. See
Results" on page 2-3.
4. Add the access points as described in

IP Discovery

Use IP discovery to discover access points in a different IP network than the Wireless Management
System. You can search for a maximum of 255 IP addresses at a time. NETGEAR recommends
that you split up your search if you have access points in multiple networks.
To use IP Discovery:
1. On the Configuration tab select Access Point Discovery, and then click the IP Discovery tab:
Access Point Discovery
"Adding Access Points" on page
v1.0, March 2010
"Discovery
2-4.
2-2