Syslog Settings - NETGEAR WMS5316 - ProSafe 16-AP Wireless Management System Reference Manual

ProSafe 16 AP Wireless Management System WMS5316 Reference Manual
• Start IP: Enter the starting IP address of the range that can be assigned by the DHCP Server.
• End IP: Enter the ending IP address of the range that can be assigned by the DHCP Server.
• Use Default DNS Server checkbox: This option allows the Wireless Management System
DNS server to be provided to the clients of the specified VLAN.
• Primary DNS Server: Enter the IP address of the primary DNS server for the network.
• Secondary DNS Server: Enter the IP address of the secondary DNS Server for the network.
• DHCP Server List: This displays DHCP server configuration for all configured VLANs.

Syslog Settings

This page lets you configure the settings to connect to a Syslog server, if you have one configured
in your network. Click the Config tab and select System > Advanced.
Figure 1-7
• Enable Syslog: Enable the Syslog settings, if you have a Syslog server on your network.
• Syslog Server IP Address: Enter the IP address to which the Wireless Management System
and managed access points will send all SysLogs, if the SysLog option is enabled.
• Server Port Number: Enter the port number at which your Syslog server is configured to
listen to requests.
Getting Started
v1.0, March 2010
1-9