Editing Access Point Information - NETGEAR WMS5316 - ProSafe 16-AP Wireless Management System Reference Manual

ProSafe 16 AP Wireless Management System WMS5316 Reference Manual
the Edit page for each access point to change its IP settings, VLAN settings, and password.
Table 6-1. Status Field Definitions
Status Implies
Connected Normal operation. The Wireless
Management System is able to
contact the access point and
manage it.
Authentication The password configured during
Failure synchronization from the Wireless
Management System is not the
same as the password of the
access point.
Not Connected The Wireless Management
System cannot connect to the
access point with the configured IP
address.

Editing Access Point Information

Figure 6-2
• Name: The unique name of managed access point.
• Model: The access point model. The field cannot be modified; it is set when the access point is
added to the list.
• User Name: The user name for logging in to the access point. This field is not modifiable.
6-2
How to Correct
N/A
Select the access point and click Edit. In the Edit
page, configure the correct password of the
access point and click Apply. The Wireless
Management System will try synchronization again
with the access point
The Wireless Management System tries to log in
to managed access points every 1 minute. If the
error is temporary, then the status will
automatically change to connected. If the error is
prolonged, verify the access point IP address and
network connectivity.
v1.0, March 2010
.
Configuring Access Point Groups