Adding Access Points - NETGEAR WMS5316 - ProSafe 16-AP Wireless Management System Reference Manual

ProSafe 16 AP Wireless Management System WMS5316 Reference Manual
• If discovery results show unknown access points, it could be due to these reasons:
– The access point is running an older version of firmware. Upgrade firmware as needed so
that discovery can locate the access point.
– The Wireless Management System located a NETGEAR access point that is not supported
or located a NETGEAR device that is not an access point.
For a list of compatible access point models and their supported firmware, see
Access Point Supported Firmware Versions" in Appendix
• If a new NETGEAR access point is not discovered, it might have a MAC address that the
Wireless Management System does not recognize, though this is not common. See
Discovery OUI" on page

Adding Access Points

After the Wireless Management System discovers the access points, add them so they can be
managed by the Wireless Management System.
1. On the Access Point Discovery page, select the access point and click Add.
Figure 2-3
Access Point Discovery
7-15.
v1.0, March 2010
"Compatible
A.
"Using
2-4