Snmp For Access Point Groups - NETGEAR WMS5316 - ProSafe 16-AP Wireless Management System Reference Manual

Prosafe 16 ap wireless management system
Hide thumbs Also See for WMS5316 - ProSafe 16-AP Wireless Management System:
Table of Contents

Advertisement

ProSafe 16 AP Wireless Management System WMS5316 Reference Manual

SNMP for Access Point Groups

Enable SNMP to allow the SNMP network management software, such as HP OpenView, to
monitor the managed access points by using SNMPv1/v2 protocol. These settings are only applied
on ProSafe access points which support SNMP.
Figure 7-7
Use the Group tab to select the settings for a specified group of access points. The access points
that have not been assigned any group share the settings of Group 1.
Read-only Community Name: The community string to allow the SNMP manager to read
managed wireless access point MIB Objects.
Read-write Community Name: The community string to allow the SNMP manager to read
and write managed wireless access point's MIB objects.
Trap Community Name: The community name which is associated with the IP address to
Receive Traps.
IP address to Receive Traps: The IP address of the SNMP manager to receive traps sent from
managed wireless access points.
Trap Port: The port on which SNMP manager receives traps sent from managed wireless
access points default is 162.
SNMP Manager IP: Restrict access to specified SNMP manager for doing SNMP v1/v2. Set
this as 255.255.255.255 to allow any SNMP manager to access. This setting is specific to
WG103 access points, and will not be applied to any other model of access points.
Click Apply to save the settings.
7-6
v1.0, March 2010
Maintenance

Advertisement

Table of Contents
loading

Table of Contents