Table of Contents
Advertisement
NO.
Item
55
Machine test repetition
number
56
Machine operation time
57
Machine stop time
58
Machine test mode
59
Unuse
60
Unuse
61
Memory switch 1
62
Memory switch 2
63
Memory switch 3
64
Memory switch 4
65
Memory switch 5
66-
Memory switch 6-16
76
*
When the setting for the memory switch 1 (environment parameter No. 61) is set to ON and
the home position is to be set , the center knife moves up and down. Be careful in order not
to be injured and not to put cloth and the like around the knife.
Display
0 to 999
These numbers. specify the machine test repetition Nos..
Continuous operation is performed at 0.
1 to 99
These numbers specify the time of machine rotation during
the machine test.
0 to 99
These numbers specify the time of machine stoppage during
the machine test. (0 is not stop)
Press the start switch to start the test with the display "ON".
Press the "RESET" key to stop the machine.
After the power supply is set to ON, the center knife moves
up and down once when the initial home position detection
is performed.*
Not used
Used
Display timing of the error message; "The face is open."
is displayed when the face is opened.
is displayed when the feeder is going to move
with the face opened.
How to operate the movement from the feed position to the
standby position(for preventing the misoperation).
is displayed when the "FEED" key is pressed.
is displayed when the "ENTER" key is pressed
with the "FEED" key being pressed.
Carriage feed shift mode during operation with a stacker (for
preventing it from pinching cloth.).
Carriage feed starts to shift after cloth is pressed:
Carriage feed starts to shift after cloth is discharged:
Binder up in detecting home position(for preventing the carriage
feed interference during operation with a 8mm gauge.).
Not used:
Used:
Unuse
BAS-6150
Contents (configurable values)
Chapter 7 Environment setting
Initial
value
10
5
2
81
Advertisement
Table of Contents
