Retention Of Upper And Lower Threads - Brother BAS-6150 Instruction Manual

Chapter 1 Machine Preparation

4-7. Retention of upper and lower threads

q
e
w
y
50mm
i
24
1. Press the "FEED" key q to move the
carriage feed to the feed position.
r
1457S
2. Open the slide plate.
3. Cover the bobbin with the bobbin case.
Place them into the rotary hook, leaving the
end of the thread t out about 50 mm and
pull down the nipper.
t
Pull up each lower thread through a thread
hole and press "BBN. THREAD CUT" key
w to retain the threads.
(Note) Pay enough attention not to touch center knife
1458S
4. Close the slide plate.
5. By pressing down the "NDL. THREAD CUT"
u
key e, place two upper threads u onto
upper thread trimmer knife i.
6. By releasing the "NDL. THREAD CUT" key
e, revert the upper thread trimmer knife.
7. Press the "FEED" key q to move the
carriage feed to the standby position.
* When the setting for the memory switch 3 (environment
parameter No.63) is set to ON, press the "ENTER" key r
with the "FEED" key q being pressed.
1459S
BAS-6150
y.