Brother BAS-6150 Instruction Manual page 4

2 Notes on safety
Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the
wall outlet before opening the face plate of the control box. Touching areas where high voltages are
presant can result in severe injury.
Use the machine in an area free of the impact
from sources of strong electrical noise such
as high-frequency welders. Sources of strong
electrical noise may cause problems with
correct operation of the machine.
Any fluctuations in the power supply voltage
should be within ±10% of the rated voltage
for the machine. Voltage fluctuations greater
than this range may cause problems with
correct operation of the machine.
The power supply capacity should be greater
than the requirements for electrical consump-
tion of the machine. Insufficient power sup-
ply capacity may cause problems with cor-
rect operation of the machine.
The air supply capacity should be greater
than the requirements for air consumption of
the machine. Insufficient air supply may
cause problems with correct operation of the
machine.
Machine installation should be carried out
only by a qualified technician.
Contact your Brother dealer or a qualified
electrician for any electrical wiring.
The machine weighs 225kg. The installation
should be carried out by two persons or more.
Do not plug in the power cord before the in-
stallation is completed. Unintended press on
the foot switch may cause injury.
Be sure to connect ground. Insecure ground-
ing may cause problems with correct opera-
tion and a serious electrical shock.
2
DANGER
CAUTION
Requirements for environment
Installation
BAS-6150
The ambient temperature during use should
be within the range from 5°C to 35°C Tempera-
ture lower or higher than this range may cause
problems with correct operation of the machine.
The relative humidity in operation should be
within the range from 45% to 85% and no dew
formation should occur in any device. Excessive
dry or humid environment and dew formation may
cause problems with correct operation of the ma-
chine.
Avoid exposure to direct sunlight in operation.
Exposure to direct sunlight may cause prob-
lems with correct operation of the machine.
When an electrical storm occurs, turn off the
power and plug off the power cord. Lighten-
ing may cause problems with correct opera-
tion of the machine.
Do not use the machine outdoors.
Be sure to wear protective goggles and gloves
when handling lubricating oil or grease so that
no oil or grease gets into your eyes or onto your
skin. Do not eat or drink lubrication oil or grease
in order not to have vomiting or diarrhea. Keep
oil and grease out of the reach of children.
Install the machine well apart from sources
of strong electrical noise such as high-fre-
quency welding equipment. Otherwise, incor-
rect machine operation may result.
Place the leveling sheet on the sound floor
and secure the machine with casters so that
it will not move.