Chapter 4 Oiling
3. How to raise the head
Turn off the power switch before oiling. Otherwise, unintended press on the foot switch may cause
injury.
Disconnect the air hoses from the air supply and wait for the needle on the pressure gauge to drop to
"0" before carrying out inspection, adjustment and repair of any parts which use the pneumatic equip-
ment.
Pay enough attention to safety when adjusting is needed with the power switch and air supply ON.
Maintenance and inspection of the machine should be performed only by technicians who have been
properly trained.
1. Lift up cloth slide plate q and turn it to be perpendicular.
2. Dismount pivot pin w from the sub table.
3. Pull and lock shaft stopper e located at the rear and lower end.
4. Dismount hook t from support metal fitting r at front and lower side and raise the machine.
5. Detach catch clip y and oil pan u.
e
q
1488S
56
CAUTION
w
BAS-6150
y
r
t
u
1489S