Table of Contents
Advertisement
u ∆∇
Programs Nos. and cycle program Nos. are changed.
i L
Settings for corner knife operation are changed. The speed is changed in the cycle program setting
mode. The lower thread counter is changed in the lower thread counter setting mode.
o M
Settings for center knife operation are changed. If the center knife is set to OFF when the
corner knife is set to ON, the setting for the corner knife is automatically changed to OFF.
The speed is changed in the cycle program setting mode. The lower thread counter is changed
in the bobbin counter setting mode.
!0 Program No. display window
Program No. or parameter No. is displayed.
!1 Contents display window
Contents of the program or those of the parameter are displayed.
!2 Display of knife setting
[CUTTER]: The lamp turns on when the center knife operation setting is ON.
[CORNER CUT]: The lamps turns on when the corner knife operation setting is ON.
!3 Setting menu
The menu to be displayed can be changed by pressing the "SELECT" key t.
Displays in the display window and key functions, when each menu is selected, are as shown
below.
[S.LENGTH]
Display of seam length and flap
Program No. display window !0
Program No.
Setting is performed for the cycle program.
Contents display window !1
Seam length
Left flap
Right flap
*
When the cycle program is selected, the progress is changed within the cycle program.
The program is locked.
Reference position
Front reference
Center reference
Rear reference
Stacker used
Program No. change *1
Setting for the center and corner knives
BAS-6150
Chapter 2 Sewing flow
∆∇ u
Li, Mo
29
Advertisement
Table of Contents
