Brother BAS-6150 Instruction Manual page 80

Chapter 7 Environment setting
NO. Item
13 Center knife offset - end of
sewing correction
14 Corner knife home position
detection
15 Corner knife offset - start of
sewing correction
16 Corner knife offset - end of
sewing correction
17 Start switch allocation
18 Steps start
19 Auto start
20 Standby time for the start of
sewing
21 Foot switch operation
22 Settings for the foot switch
timer
23 Distance to start releasing
the upper thread retention
24 Upper thread retention
releasing time
25 Upper thread trimming
knife descent timing
78
Display
-9.9 to 9.9mm (in the unit of 0.1 mm)
To be detected only for power on and emergency stop
To be detected for every sewing
-9.9 to 9.9mm (in the unit of 0.1 mm)
-9.9 to 9.9mm (in the unit of 0.1 mm)
Right foot switch
Center foot switch
Setting is performed as for which foot switch should be functioned as
a start switch.
Operation stops at the needle down position after feeding
and sewing starts again when the start switch is set to ON.(
for confirmation of the cloth guide)
Set auto start to
presser goes down.
0.0 to 99 second(s)
Setting is performed as for how many seconds later sewing
is to start when the auto start is ON and when the start
switch is pressed.
Step
Timer (programmable)
Setting is performed for operation interval by setting the
display to ON and with operation of the foot switch.
0 to 30 mm (in the unit of 1 mm)
Distance from the start of sewing to the start of releasing the
upper thread.
When the distance is set to 0, the upper thread is released
before the machine rotates. This function can works when
the upper thread is stitched in at the start of sewing. The end
of releasing is operated by the timer. No.24
0.005 to 0.1 second
Releasing time of the upper thread retention.
0 to 50 mm (in the unit of 1 mm)
Distance from the end of sewing to the start of the upper
thread's descent.
(This setting is performed to adjust the amount of the
remained upper thread.)
BAS-6150
Contents (configurable values)
in certain time after the last
Initial
value
0.0
0.0
0.0
0.0
10
0.020
30