How To Operate The 3-Pedal Switch - Brother BAS-6150 Instruction Manual

Chapter 2 Sewing flow

1-2. How to operate the 3-pedal switch

1) Function of the start (foot) switch
• Starting automatic sewing on the auto mode
• Starting at each step on the test mode
• Performing the returning of the carriage feed to the home position when the power switch
is set to ON or after the emergency stop switch is released.
• Starting the set of the flap correction factors on the programmed mode
2) Function of the (foot) forward switch
The following function is performed depending on the number of press-down
• 1st One or both of carriage feeds go down. ( Setting is needed.)
• 2nd One of carriage feeds go down. (Setting is needed.)
• 3rd The folding plate comes out after the binder goes down. (Setting is needed.)
• 4th Either left or right one of flap clamps goes down. (Setting is needed.)
• 5th Either left or right one of flap clamps goes down. (Setting is needed.)
3) Function of the (foot) backward switch
Revert one step of the previous clamping action at each press-down.
* The function of start switch can be added to the forward switch 2).
* The above description illustrates the initial settings. Setting for the addition is performed with the envi-
ronment parameter No. 17 [Start switch allocation]. (Refer to [Chapter 7 Environment setting].) After set-
ting change, press the switch again after all pressers go down with the forward switch pressed.
32
1)
2)
3)
1460S
Carriage feed (L)
Flap clamp (L)
BAS-6150
Binder
Flap clamp (R)
Carriage feed (R)
Folding plates
1461S