Basic > Defaults > Time; Basic > Defaults > Reset - Kyocera FS C5015N - Color LED Printer Operation Manual

Basic > Defaults > Time
Basic > Defaults > Reset
COMMAND CENTER
Assigns an IPv6 address to the printing system network component. The
format of the IPv6 address is a sequence of numbers (128 bit in total)
separated by colons, e.g. 2001:db8:3c4d:15::1a2c:1a1f.
• Prefix Length
Specifies the IPv6 prefix length of the hosts or network with which the print
system is connecting.
• RA (Stateless)
Select On to use RA to configure IPv6 addresses.
• Default Gateway
Specifies the IPv6 address of the default gateway.
• DHCPv6
Specifies whether or not to obtain IPv6 IP addresses by automatic
configuration. When RA is turned On, the IP addresses and server
information are obtained via DHCPv6 based on the settings of the automatic
configuration made under RA (router setting).
If a time server is used to synchronize the time as well, the current time can be
adjusted regularly and easily. Enter the IP address of the time server and click
the Synchronize button.
Time information is required when you receive reports from this machine via
E-mail. It is recommended that you set the time when the report mail function is
enabled.
Current Local Time
Displays the time that is currently set in the machine.
Current Universal Time (UTC/GMT)
Displays the Greenwich Mean Time that is currently set in the machine.
Time Zone
Sets a time difference. Click the drop down list and select your region.
Summer Time
Switches the Summer Time setting On and Off. Select On in order to have
the Summer Time function applied when the time is synchronized with a time
server.
Time Server
Enter the host name or IP address of the time server from which you want to
acquire the time.
Synchronize with Time Server now
Click the Synchronize button to synchronize the registered time with the
designated timer server.
Synchronization Status
Displays the results of the synchronization operation with the time server.
This page allows you to restart the machine in order to make all settings in the
machine valid. It is also possible to select to have all settings returned to their
factory default values.
Restart entire device
COMMAND CENTER Pages
3-6