Acl Meter Configuration; Acl Re-Mark Configuration - HP 445860-B21 - 10Gb Ethernet BL-c Switch Command Reference Manual

ACL Meter configuration

Command: /cfg/acl/acl <1-384>/meter
[Metering Menu]
This menu defines the metering profile for the selected ACL.
Table 165 ACL Meter Configuration Menu options
Command
cir <1000-10000000>
mbsize <32-4096>
enable e|d
dpass drop|pass
reset
cur

ACL Re-mark configuration

Command: /cfg/acl/acl <1-384>/re-mark
[Re-mark Menu]
You can choose to re-mark IP header data for the selected ACL. You can configure different remark
values, based on whether packets fall within the ACL Metering profile, or out of the ACL Metering profile.
ACL Re-mark Configuration Menu options
Table 166
Command
inprof
outprof
reset
cur
cir - Set committed rate in KiloBits/s
mbsize - Set maximum burst size in KiloBits
enable - Enable/disable port metering
dpass - Set to Drop or Pass out of profile traffic
reset - Reset meter parameters
cur - Display current settings
Description
Configures the committed rate, in Kilobits per second. The committed rate must be a
multiple of 1,000.
Configures the maximum burst size, in Kilobits. Enter one of the following values for
mbsize: 32, 64, 128, 256, 512, 1024, 2048, or 4096.
Enables or disables metering on the ACL.
Configures the ACL Meter to either drop or pass out-of-profile traffic.
Reset ACL Metering parameters to their default values.
Displays the current ACL metering parameters.
inprof - In Profile Menu
outprof - Out Profile Menu
reset - Reset re-mark settings
cur - Display current settings
Description
Displays the Re-mark In-Profile Menu.
Displays the Re-mark Out-of-Profile Menu.
Reset ACL Re-mark parameters to their default values.
Displays the current ACL re-mark parameters.
Configuration Menu
193