Port Link Configuration - HP 445860-B21 - 10Gb Ethernet BL-c Switch Command Reference Manual

Port link configuration

Command: /cfg/port <port number>/gig
[Gigabit Link Menu]
Use these menu options to set port parameters for the port link.
Link menu options are described in the following table and display on the Gigabit port configuration
menus for the switch. Using these configuration menus, you can set port parameters such as speed,
duplex, flow control, and negotiation mode for the port link.
The following table describes the Gigabit Link Configuration Menu options.
Table 100 Gigabit Link Configuration Menu options
Command
speed 100|10000
mode
fctl rx|tx|both|none
auto on|off
cur
speed - Set link speed
mode - Set full or half duplex mode
fctl - Set flow control
auto - Set auto negotiation
cur - Display current gig link configuration
Description
Sets the link speed.
NOTE: All downlink and uplink ports are fixed at 10000 Mbps, and cannot be
changed. Management port 17 is fixed at 100 Mbps.
Sets the operating mode, as follows:
Full-duplex
All ports are fixed at full duplex, and cannot be changed.
NOTE:
Sets the flow control. The choices include:
Receive (rx) flow control
Transmit (tx) flow control
Both receive and transmit flow control (default)
No flow control
NOTE: Management port 17 is fixed at both, and cannot be changed.
Enables or disables auto-negotiation for the port.
NOTE: All downlink and uplink ports are fixed at 10000 Mbps, and cannot be
set to auto-negotiate.
Displays current port parameters.
Configuration Menu
136