Spanning Tree Configuration - HP 445860-B21 - 10Gb Ethernet BL-c Switch Command Reference Manual

Spanning Tree configuration

Command: /cfg/l2/stp <1-128>
[Spanning Tree Group 1 Menu]
The HP 10GbE switch supports the IEEE 802.1d Spanning Tree Protocol (STP) and Cisco proprietary PVST
and PVST+ protocols. You can configure up to 127 spanning tree groups on the switch (STG 128 is
reserved for switch management). Spanning Tree is turned on by default.
NOTE:
When RSTP is turned on, only STP group 1 can be configured.
The following table describes the Spanning Tree Configuration Menu options.
Spanning Tree Configuration Menu options
Table 110
Command
brg
port <port number>
add <1-4094>
remove <1-4094>
clear
on
off
default
cur
brg - Bridge parameter menu
port - Port parameter menu
add - Add VLAN(s) to Spanning Tree Group
remove - Remove VLAN(s) from Spanning Tree Group
clear - Remove all VLANs from Spanning Tree Group
on - Globally turn Spanning Tree ON
off - Globally turn Spanning Tree OFF
default - Default Spanning Tree and Member parameters
cur - Display current bridge parameters
Description
Displays the Bridge Spanning Tree Menu.
Displays the Spanning Tree Port Menu.
Associates a VLAN with a spanning tree and requires an external VLAN ID as a
parameter.
Breaks the association between a VLAN and a spanning tree and requires an external
VLAN ID as a parameter.
Removes all VLANs from a spanning tree.
Globally enables Spanning Tree Protocol.
Globally disables Spanning Tree Protocol.
Restores a spanning tree instance to its default configuration.
Displays current Spanning Tree Protocol parameters.
Configuration Menu
147