Table 99
Port Configuration Menu options
Command
drate <0-262143>|dis
ena
dis
cur
Temporarily disabling a port
To temporarily disable a port without changing its stored configuration attributes, enter the following
command at any prompt:
Main# /oper/port <port number>/dis
Because this configuration sets a temporary state for the port, you do not need to use apply or save.
The port state will revert to its original configuration when the switch is reset. See the "Menu information"
section in the "Operations Menu" chapter for other operations-level commands.
Description
Limits the number of unknown unicast packets per second to the specified value. If
disabled (dis), the port forwards all unknown unicast packets.
Enables the port.
Disables the port. To temporarily disable a port without changing its configuration
attributes, see the "Temporarily disabling a port" section later in this chapter.
Displays current port parameters.
Configuration Menu
135