Routing Information Protocol Configuration; Rip Interface Configuration - HP 445860-B21 - 10Gb Ethernet BL-c Switch Command Reference Manual

Routing Information Protocol configuration

Command: /cfg/l3/rip
[Routing Information Protocol Menu]
The RIP Menu is used for configuring Routing Information Protocol parameters. This option is turned off by
default.
The following table describes the RIP Configuration Menu options.
RIP Configuration Menu options
Table 131
Command
if <1-249>
update <1-120>
redist
on
off
cur

RIP Interface configuration

Command: /cfg/l3/rip/if <1-249>
[RIP Interface 1 Menu]
The RIP Menu is used for configuring Routing Information Protocol parameters. This option is turned off by
default.
NOTE:
Do not configure RIP version 1 parameters if your routing equipment uses RIP version 2.
if - RIP Interface Menu
update - Set update period in seconds
redist - RIP Route Redistribute Menu
on - Globally turn RIP ON
off - Globally turn RIP OFF
current - Display current RIP configuration
Description
Displays the RIP Interface menu.
Configures the time interval for sending for RIP table updates, in seconds.
The default value is 30 seconds.
Displays the RIP Route Redistribute menu.
Globally turns RIP on.
Globally turns RIP off.
Displays the current RIP configuration.
version - Set RIP version
supply - Enable/disable supplying route updates
listen - Enable/disable listening to route updates
poison - Enable/disable poisoned reverse
split - Enable/disable split horizon
trigg - Enable/disable triggered updates
mcast - Enable/disable multicast updates
default - Set default route action
metric - Set metric
auth - Set authentication type
key - Set authentication key
enable - Enable interface
disable - Disable interface
current - Display current RIP interface configuration
Configuration Menu
164