Disabling The Panel Lock - Epson AcuLaser MX14 User Manual

3. Select Secure Settings, and then press the
4. Select Panel Lock, and then press the
5. Select Panel Lock Set, and then press the
6. Select Enable, and then press the
7. As necessary, select Change Password, and change the password using the numeric keypad.
Then, press the
Note:
The factory-default panel password is 0000.
Note:
❏ Be sure to remember the password. The procedure described below allows you to reset the password.
However, for the Epson AcuLaser MX14NF, the settings for the Address Book are cleared.
1. Turn off the printer. Then, while holding the System button, turn on the printer.
❏ If you change the password while Panel Lock Set is Enable, perform steps 1 to 2. Enter the
current password, and then press the
and then press the
change the password.

Disabling the Panel Lock

Note:
❏ For the Epson AcuLaser MX14NF, you can select Disable for Panel Lock Set when all items
under Service Lock are set to Unlocked and Secure Receive Set is set to Disable.
❏ For the Epson AcuLaser MX14, you can select Disable for Panel Lock Set when all items under
Service Lock are set to Unlocked.
1. Press the System button.
2. Select Admin Menu, and then press the
3. Enter the password, and then press the
4. Select Secure Settings, and then press the
5. Select Panel Lock, and then press the
button.
button.
button. Perform steps 3 to 4. Select Change Password,
button. Enter the new password, and then press the
Epson AcuLaser MX14 Series
button.
button.
button.
button.
button.
button.
button.
Using the Operator Panel Menus and Keypad
User's Guide
button. This will
248