Sending A Fax Manually; Confirming Transmissions - Epson AcuLaser MX14 User Manual

Sending a Fax Manually

1. Load the document(s) face up with top edge in first into the ADF or place a single document face
down on the document glass and close the document cover.
See Also:
❏ "Loading an Original Document on the ADF" on page 176
❏ "Loading an Original Document on the Document Glass" on page 177
2. Press the (Fax) button.
3. Adjust the document resolution to suit your fax needs.
See Also:
❏ "Resolution" on page 178
❏ "Lighten/Darken" on page 179
4. Select OnHook, and then press the
5. Select On, and then press the
6. Enter the fax number of the remote fax machine using the numeric keypad.
❏ If the document is loaded on the ADF, press the
❏ If the document is not loaded on the ADF, press the
setting, and then press the
Note:
Press the (Stop) button to cancel the fax job at any time while sending the fax.

Confirming Transmissions

When the last page of your document has been sent successfully, the printer beeps and returns to the
standby mode.
If something goes wrong while sending your fax, an error message appears on the LCD panel.
If you receive an error message, press the
again.
button.
button.
(Start) button.
button.
button to clear the message and try to send the document
Faxing (Epson AcuLaser MX14NF Only)
Epson AcuLaser MX14 Series
(Start) button, select the desired
User's Guide
182