Epson AcuLaser MX14 User Manual page 211

TCP/IP
Purpose:
To configure TCP/IP settings. The change becomes effective after the printer is turned off and then
on.
Values:
IP Mode Dual Stack*
IPv4
IPv4 Get IP Address
IP Address
Subnet Mask
Gateway Address
Note:
To configure the IPv6 settings, use EpsonNet Config.
Protocol
Purpose:
To enable or disable each protocol. The change becomes effective after the printer is turned off and
then on.
Values:
LPD
Port 9100
AutoIP*
BOOTP
RARP
DHCP
Panel
Disable Disables the Line Printer Daemon (LPD) port.
Enable* Enables the LPD port.
Disable Disables the Port 9100 port.
Enable* Enables the Port 9100 port.
Epson AcuLaser MX14 Series
Uses both IPv4 and IPv6 to set the IP address.
Uses IPv4 to set the IP address.
Automatically sets the IP address.
Uses BOOTP to set the IP address.
Uses RARP to set the IP address.
Uses DHCP to set the IP address.
Enables the IP address entered on the operator panel.
Manually sets the IP address allocated to the printer.
Manually sets the subnet mask.
Manually sets the gateway address.
Using the Operator Panel Menus and Keypad
User's Guide
211