Reset Configuration - HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

Using Maintenance Features

Reset Configuration

Note:
This option resets all configuration data input through options in the Configure
menu, zoning configurations, and switch addressing to factory-default values.
Since the current IP address for the switch may not match the factory default
address, the Ethernet link between the switch and the service processor may drop
and not reset. Before using this option, record the switch's current IP address
which displays below the switch's icon in the HAFM's Product View (view
Display Options set to Network Address). You can also find the current IP
address through the Embedded Web Server interface.
After resetting the configuration, you must reset the original address on the switch
through the maintenance port or the Embedded Web Server interface to maintain
LAN connections and communication with the service processor.
To reset the configuration, use the following steps:
1. Set the switch offline. For instructions, refer to
2. Select Reset Configuration from the Maintenance menu on the menu bar.
Note:
was shipped from the factory, these features will be disabled (factory default) when the
configuration is reset. Only those ports that were enabled at the factory will function.
You will have to enable the additional port function features again through the
Configure Feature Key dialog box.
164
You must have maintenance authorization rights to access this feature.
page 158.
The following warning displays:
WARNING: This operation will reset all switch configuration data and
non-volatile settings to factory default values. All optional features will also be
disabled. The switch must be offline to continue.
If you have enabled features that add additional port function since the switch
"Set Online
Edge Switch 2/24 Product Manager User Guide
State" on