HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual page 196

Product Manager Messages
Table 5: StorageWorks Edge Switch 2/24 Product Manager Messages (Continued)
Invalid worldwide
Name.
Link dropped.
Log is currently in use.
Loopback plug(s) must be
installed on ports being
diagnosed. Press Next to
continue.
Maximum number of
versions already
installed.
No file was selected.
No firmware version file
was selected.
No firmware versions to
delete.
Non-redundant switch
must be offline to install
firmware.
Not all of the optical
transceivers are installed
for this range of ports.
194
Message
Worldwide name must
have eight two-digit
hexadecimal numbers
separated by colons
(xx:xx:xx:xx:xx:xx:xx:xx)
Connection between
HAFM server and the
switch has been lost.
Log is in use by another
Product Manager.
External loopback
diagnostics require an
optical loopback plug to
be installed.
The maximum number of
firmware versions has
been reached.
Action requires you to
select a file
A file was not selected in
the Firmware Library
dialog box before an
action, such as modify or
send was performed.
There are no firmware
versions in the firmware
library to delete.
Since the switch has only
a single CTP card, it must
be offline to initiate a
firmware installation.
Note that the CTP card is
an internal component
and not a FRU.
Some ports in the
specified range do not
have optical transceivers
installed.
Description
Edge Switch 2/24 Product Manager User Guide
Action
Enter a worldwide name
using eight two-digit
hexadecimal numbers
separated by colons in the
format given in the
message.
Wait for the connection to
re-establish. Link
re-connects are attempted
every 30 seconds.
Retry the operation later.
Ensure that an optical
loopback plug is installed in
port optical transceiver
before running external
wrap diagnostic testing.
Delete a firmware version
before adding a new
firmware version.
Select a file.
Click a firmware version in
the dialog box to select it,
then perform the action
again.
N/A. An informational
message.
Take switch offline and try
again.
Use a port range that is
valid for the ports installed.