HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual page 194

Product Manager Messages
Table 5: StorageWorks Edge Switch 2/24 Product Manager Messages (Continued)
Invalid configuration
name.
Invalid feature key.
Invalid firmware file.
Invalid network address.
Invalid port number.
Invalid port number.
Valid ports are (0 - 23).
Invalid port swap.
Invalid response received
from switch.
Invalid serial number for
this feature key.
Invalid UDP port number.
Invalid value for
BB_Credit.
192
Message
Attempted to save an
address configuration
name with an invalid
name.
The feature key was not
recognized.
Selected file is not a
firmware file.
Network address
specified is not known by
the domain name server.
Port number must be
within the range of ports
for the specific switch
model.
Port number must be
within the range of ports
for the specific switch
model. For this model,
the valid port numbers
are 0 - 23.
Port swap selection is not
allowed.
The switch returned an
invalid response.
The serial number and
the feature key did not
match.
UDP port number must
be an integer from 1
through 65535.
BB_Credit must be an
integer from 1 through
60.
Description
Edge Switch 2/24 Product Manager User Guide
Action
Use up to 24 alphanumeric
characters, including
spaces, hyphens and
underscores.
Re-enter the feature key
noting the key is
case-sensitive and to
include the dashes.
Select the correct firmware
file.
Check the input address
and specify the correct
network address.
Enter a port number within
the correct range.
Enter a port number within
the correct range.
Ensure that each port
selected for swap has not
been previously swapped.
Resend the firmware. If the
condition persists, contact
support personnel.
Ensure that the feature key
being installed is
specifically for this switch
serial number.
Enter a port number from 1
through 65535.
Enter a number from 1
through 60.