Configure Date And Time; Configure Date And Time Periodic Synchronization Dialog Box - HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

Configuring the Switch

Configure Date and Time

Use the procedures in this section to display and change the date and time set on
the switch. You must set the current date and time on the switch using this dialog
box so the correct time stamps display in the Event Log, Audit Log, Hardware
Log, Link Incident Log, and Threshold Alerts Log.
Set the switch date and time using the following steps:
1. Select Date/Time from the Configure menu on the menu bar.
Figure 31: Configure Date and Time Periodic Synchronization dialog box
Note:
Sync
122
The Configure Date and Time dialog box displays.
If the Periodic Date/Time Synchronization check box in the Configure
Date and Time dialog box is selected, the HAFM server periodically
synchronizes the switch time to the HAFM server, and daylight savings time
automatically updates. When the Periodic Date/Time Synchronization
option is selected, the Date and Time fields are disabled (grayed out).
If the Periodic Date/Time Synchronization check box is not selected, you
can set the HAFM server date and time manually.
To disable Periodic Date/Time Synchronization, click the check box to
remove the check mark, then click Activate. To re-enable Periodic
Date/Time Synchronization, click the check box to display the check box,
then click Activate.
Click Activate to synchronize the date and time at the next update period. Click
Now
to synchronize the date and time immediately.
Edge Switch 2/24 Product Manager User Guide