Optional Features
Enabling and Configuring Open Trunking
To enable Open Trunking for a specific switch and configure threshold values and
event notification options, use the following steps.
1. Select Open Trunking from the Configure menu on the menu bar.
Figure 50: Configure Open Trunking dialog box
2. Enable Open Trunking by clicking the Enable Open Trunking check box to
3. Set the Congestion Thresholds for ports as percentages of link bandwidths in
178
The Configure Open Trunking dialog box displays.
display a check mark.
the range of 1% through 99%. These thresholds are used only when a port
becomes an ISL. When the link's traffic load becomes greater than this
percentage, the link is seen as congested and traffic is rerouted (if possible) to
an uncongested link. Note that rerouting may not be possible if there are no
alternate links available or if alternate links are congested or lack BB_Credits.
Edge Switch 2/24 Product Manager User Guide