Creating A New Project - Tascam HS-2 Owner's Manual

Cr e a t i n g a p r oj e c t a u t o m a t i c a l l y a f t e r q u i c k
formatting
If you touch the
QUICK & Create Project
instead of the button next to the
QUICK
a new project will be created after the card is quick-
formatted.
When doing this, however, you cannot change the project
settings. The new project will be created with the same
settings as the current project.
1 Press the MENU key on the front panel to open the
screen. Then, touch the
MENU
ton on the screen to open the
MENU
screen.
2 Touch the
Quick & Create Project
to the item. The following pop-up window
FORMAT
message appears.
This window shows the project name, session name,
sampling frequency, bit rate and frame type in the
project to be created.
3 Touch the button in the pop-up window.
OK
Another pop-up window appears to reconfirm.
4 Touch the button in the pop-up window to start
OK
quick formatting.
After quick formatting completes, a new project is
created automatically.
After the project is created, the Home Screen reopens.
NOTE
Touch the button in the pop-up window to cancel
CANCEL
formatting and return to the
button
item,
FORMAT
but-
MEDIA MANAGE
MEDIA MANAGE
button next
screen.
MEDIA MANAGE
4–Basic operation

Creating a new project

1 Press the PROJECT key on the front panel to open
the screen.
PROJECT
2 Touch the
CREATE PROJECT
screen.
CREATE PROJECT
The screen has 3 pages.
CREATE PROJECT
On the first page, you can set the project name, the
name of the first created session, and the sampling
frequency.
For details about each item, see "Creating new
projects" on page 37.
3 Touch the button to open the next page.
NEXT
On this page, you can set the frame type and bit
length.
NOTE
Instead of touching the
NEXT
button on
CREATE PROJECT
page one ( at the bottom of the page) to create a
1/3
project with the current settings without adjusting them
on the following screens. Touching the
button on
CREATE PROJECT
bottom of the page) has the same effect. In either case,
continue the procedures from step 6.
4 Touch the button again to open the third
NEXT
page where you can set the starting time in time-
line mode, for example.
For details about each item, see "Creating new
projects" on page 37.
5 After you complete making settings touch the
button.
CREATE PROJECT
button to open the
button, you can touch the
screen
CREATE PROJECT
CREATE PROJECT
page two ( at the
2/3
31
TASCAM HS-2