Table of Contents
Advertisement
Frame Type
Set the time code frame type of the currently loaded
project.
Setting buttons:
,
23.976F
,
,
29.97ND
30DF
30ND
I/O page
Set the synchronization signal status display and time
code output on this page.
NOTE
If the Option SY-2 has not been installed, the display is
shaded and the setting cannot be selected.
STATUS
This shows the status of synchronization signals.
TIMECODE IN:
When time code is input, the time code frame rate is
shown.
WORD/VIDEO IN:
When a synchronization signal is detected at this
connector,
,
WORD
VIDEO
TC Out Mode
Use the buttons to set the time code output mode.
GenOut button:
Time code is output from the internal time code
generator.
PlayOut button (default):
In timeline mode, the time code time for playback and
recording is output. In take and playlist modes during
playback, the time code recorded in the file is output.
,
,
(default),
24F
25F
29.97DF
or
is shown.
TriLevel
10–Internal settings
Remote settings (REMOTE SETUP)
Make settings for the PARALLEL, RS-232C, RS-422 and
Ethernet (Network) connectors.
The
screen has 5 pages:
REMOTE SETUP
,
,
PARALLEL
RS-232C
RS-422
the tabs at the bottom of the screen to open the corre-
sponding page.
GENERAL page
Make the external remote controller settings on this page.
FADER MODE
Allows the fader on an external TASCAM RC-HS20PD
remote controller (sold separately) to be enabled or
disabled. When set to
Disable
at 0 dB.
Setting buttons:
,
Disable
Enable
FADER Start MODE
When the fader start function of an external TASCAM
RC-HS20PD remote controller (sold separately), for
example, is on, set whether fader starts, which allows
you to start playback by raising the fader from ∞ when in
playback standby, is enabled or not.
Setting buttons:
,
Disable
Enable
FADER Stop MODE
When the fader start function of an external TASCAM
RC-HS20PD remote controller (sold separately), for
example, is on, set whether fader stop, which allows you
to put playback into standby by lowering the fader to ∞
during playback standby, is enabled or not.
Setting buttons:
,
Disable
Enable
NOTE
If both the
FADER Start MODE
items are set to
, the fader start function of the
Disable
external TASCAM RC-HS20PD remote controller (sold
separately) will be turned off automatically, and the
FADER START indicator will turn off. In this state, if you
touch the Fader Start key on the TASCAM RC-HS20PD
remote controller, a "
Cannot Change Now. Fixed in
" warning appears in a pop-up window.
current mode
,
GENERAL
and
. Touch
ETHERNET
, the internal fader is fixed
(default)
(Default)
(Default)
and
FADER Stop MODE
95
TASCAM HS-2
Advertisement
Table of Contents
