8-Take Mode; Preparing To Record; Basic Preparations; Creating A New Project - Tascam HS-2 Owner's Manual

8–Take mode
In this chapter, we explain how to use the take mode. To
use this unit in take mode, set the unit's operation mode
to TAKE MODE. (See "Selecting the operation mode" on
page 44.)
Please refer to "4–Basic operation" on page 29 when reading
this chapter.

Preparing to record

Basic preparations

Refer to"4–Basic operation" on page 29 and make the basic
preparations for recording.

Creating a new project

Create new projects as necessary. You do not need to
create a new project if you plan to record into an existing
one.
1 Press the PROJECT key on the front panel to open
the screen.
PROJECT
2 Touch the
CREATE PROJECT
screen to open the
CREATE PROJECT
On this screen, set the project name, the name for the
first session and the sampling frequency.
Touch the button to open the next page.
NEXT
Set the frame type then bit length.
Touch the button to open the next page.
NEXT
64
TASCAM HS-2
button on the
PROJECT
screen.
Finally, set the starting time in timeline mode, and
then set whether other settings should be retained
from the currently open project or whether the factory
defaults should be used instead.
For further details about these settings, see "Editing
the project name" on page 38.
3 After you complete making settings touch the
button.
CREATE PROJECT
NOTE
If a project with the same project name already exists, the
button appears gray and you will not
CREATE PROJECT
be able to create a new project. If this happens, change
the project name.
4 Touch the button when the confirmation pop-
OK
up message appears.
When creation of the project completes, the Home
Screen reopens.

Creating new sessions

Create new sessions as necessary. You do not need to
create a new session if you plan to record into an existing
one.
1 Press the PROJECT key on the front panel to open
the screen.
PROJECT
2 Touch the button of the project in which you
e
want to create a new session to open its session se-
lection screen.
If it is not the current project, a pop-up window
appears confirming that you want to load it. Touch the
button.
OK
3 Touch the
MAKE SESSION
screen.
SESSION
button to open the
MAKE